I have 4 DJ Spot 250's I can't seem to synch up their movement with the actual fixtures and the fixtures on the visualizer (it synchs up for maybe like the middle half of the X and Y values but not completely 0-255). I have them set up on the floor on stage and on the visualizer so DZ and DY are at "0" and DX is at 180. Can these lights be synched %100 or is it a guessing game? I'd like to be able to take my laptop to work with me and during break design new scenes but then when I hook up to the lights, the spot 250s' arent doing what the vizualizer shows..Any suggestions?

I could take a look at the profile cause if the maximum pan and tilt values are wrong on the profile it won't be the same in the 3d. This could be one reason. So let me know the max pan and tilt angles and I'll check it fir you. Thanks. Also the 3D is a bit if a guessing game. It does provide a very good job at being able to design and program remotely but I would never bet 100% on it. In fact I highly doubt anyone in the lighting industry relies 100% on a 3D rendering. Sincerely,