If anyone can help please let me know, I have 4 DJ Scans in sequence, the first two are working good, the second two had blown bulbs so i replaced them and the head will not move nor will the light come on. I tried setting each individual light to master. still nothing is there a way to reset these things, I checked the fuses and they are still good the fan comes on so I know they are getting power and the input sigal flashes also but still nothing. If anyone has any ideas please help, I'm in a bind cause I have to use them in about an hour, but I can still use the two that are working. Thx.

Dustin Wascom,
Firehouse Bar & Grill
Covington, LA

set the dip switches to "0". Then tuen the light off and turn in on. When it truns on (of it turns on) it will run through a few second cycle and then will stop moving. Make sure the sensitivity knowb is turned up so it canrun on audio mode. See if this helps.

-AMP

they wont even come on at all only the fan and the input signal light

the head doesnt even move

Is there a troubleshooting guide or a tech manual available anywhere for these lights?

The same thing happened to me on a light I had, but the fan didnt even come on, nor did the flashy signal light. It worked for a day then quit. I sent mine back and got a new one, but I suggest you call ADJ support. There's something that isnt telling the bulb and the stepper motors to come on/move

call 800 322 6337 ask for customer support