example :
the strobe is from values 7 to 251, and the reset is the value 30

My question is: If I do a fade from 7 to 251, will I have a blank frame when it will come across 30 ?

Thank you

you are really of a great help...

in two questions posted, two un-answered

sorry for the delay im on a trip in atlanta for the WFX show with elation. yeah u prob will get a fade up of blackness. unless u have a console that can aply the fade times to certain channels and take fade times off aswell to crtain channels. peace! jingles.

I'm looking at the traits for the ScanTron 250, and I don't see a fixture reset listed among any of the channel assignments.

On channel 5, values 7-251 are for adjusting the flash rate for the strobe, but nothing is noted about a reset...

By the term 'reset' do you mean fixture reset or strobe reset?

It's a fixture reset
I tested it and it invoke the startup initialization.... not good in live

you can go to
http://www.martin.dk/forum/images/IMGA0897.JPG

I posted a picture of my user manual (because I think the PDF on the website is out of date, because I programmed my lights before receiving them, and when I plugged it all, they were not behaving the way it was described in the PDF.

Well, hmm.

That is a really bad place for a fixture reset. I don't get it.

Fading up on that channel trough value 30 will likely cause it to reset, unless you have to let that value sit for a few seconds to activate.

That's all I can think of. Sorry.

ok, so I must not do a very slow fade so they don't have the time to reset...

I wonder why they done that, and the purpose of this.
anyway.. thank you for the informations

actually from what i have found in order for the reset function to kick in u have to let the values set for about 5 secs or so to have them activate. im prety sure about this. why not try it and let us know? peace! jingles