hello @all,

as first i have to say sorry for my english. i'm a german.

i got a serious problem. i use two 64p led par's and i started to control them via software. in the manual i read, that there are 3 possible dmx-modes. i switched to 3-ch-mode. the first i wonder is, that the 3 digits are blinking all the time. i didn't read about this anywhere in the manual. as 2nd i nowhere can find, how i can make a general reset of the par's. i'm not sure, if they are okay in dmx-mode.
they don't work in dmx! my software and my hardware dmx-converter seems to be okay, but the par's don't react of any dmx-command. what can i do? i was trying another software, but i got the same result.

okay, i could solve the problem and found out the failure. i made a failure on soldering the dmx-converter.

now it works and i understand the blinking of the dmx-status: it does, when no dmx-signal comes in.

@mods: you can close this post, if you want.

thanks a lot to all.